Nilang Series

Nilang right angle fastener

Right angle fasteners must be manufactured in accordance with the drawings approved in accordance with the prescribed procedures. The material of fastener shall conform to the mechanical properties specified by KTH330-08 grades in GB9440. The production of fasteners must be batched according to the batching ratio specified in the process. Fastener heat treatment strictly implement the temperature and time of each stage of the process. Fasteners shall be processed in strict accordance with the process, and the bonding surface between the fastener and the steel pipe shall be tested and reshaped to ensure the requirements of anti-slip and tensile properties of the fastener. Fasteners (except the base) must be tested by 70N.m torsion torque pressure test, and no damage is allowed. Anti-sliding performance of right angle fastener, when P = 14KN, △ 2 ≤ 0.5mm. Tensile performance of butt fastener: when P = 6KN, △ 2 ≤ 0.2mm. No more than one sand hole with a sand hole area greater than 10 mm² is allowed, and the cumulative area shall not be greater than 40 mm².